OnePlus 2 speaker repair guide

The speaker won’t play any music.

In this repair guide, we show you how to replace your OnePlus 2 defective speaker on your own. You need this repair if your phone doesn’t play music or only plays it quietly, or if your ring tone doesn’t play when you get calls. Your OnePlus 2 will no longer be waterproof after this repair.

Required tools

Phillips PH00 screwdriver

Phillips PH00 screwdriver

You need the right screwdriver for removing PH00 screws.
from €10.84 on Amazon

Show all replacement parts for the OnePlus 2

Steps

11 Steps

Switch off device

Step 1

Removing the back cover

Step 2

Removing the SIM card tray

Step 3

Removing the plastic cover

Step 4

Removing the battery

Step 5

Inserting the speakers

Step 6

Removing the speakers

Step 7

Installing the battery

Step 8

Attaching the plastic cover

Step 9

Inserting the Sim tray

Step 10

Attaching the back cover

Step 11

Getting started with the repair of your OnePlus 2

If you get stuck or have questions, you can post a comment. We’d be happy to help.

11 steps

Switch off device
Turn off your device by holding down the power button until the “Power off” option appears.
Use your finger to confirm that you want to shut down your OnePlus 2 and wait until the screen goes blank.
Removing the back cover
Insert a thin, flat, tapered spudger into the gap at the corner of your smartphone. There are several clips on the outside under the back cover. You have to disconnect them by moving the spudger around the entire smartphone one time. Alternatively, you can detach the back cover using your fingernails.
Then you can take off the back cover.
Removing the SIM card tray
You can use the SIM Tool or a paperclip to remove the SIM card tray. Press the SIM Tool into the small hole in the SIM card tray to remove it.
Removing the plastic cover
6 × Gummiabdeckung

18 × Phillips-Schraube

Remove all 18 Phillips screws that hold the plastic cover in place.
6 Phillips screws are hidden under a rubber cover. Use a sharp object to lift out the cover.
Lift out the logic board cover. Carefully insert the pointed tip of the ESD spudger and lift the black cover. Also pry it out at other points.
Removing the battery
If your OnePlus 2 is still on, turn it off now by holding down the standby button for about three seconds and following the prompt on the display.

Now you can detach the battery connector. Be very careful. Place the pointed tip of the spudger very slightly below the contact and carefully lift it up. The pictures show where you should put the spudger to avoid breaking off the little resistors even if it slips.
The battery is slightly glued to the cover. You can warm it, ot remove it more easily.

Now lift the battery with the spudger and then remove it.

Inserting the speakers
Now install the cover with the stereo speakers and put them back in the appropriate positions.
Removing the speakers
Now you can disconnect the following connectors. Be very careful.

Insert the flat end of the spudger below the cover at the level of the charging port and carefully lift the cover. The stereo speakers are under it.
Make sure you don’t break off the resistors/coils that are soldered onto the logic board.

Now you can remove them.
Installing the battery
Put the battery back in and connect it.
Attaching the plastic cover
18 × Phillips-Schraube

6 × Gummistöpsel

Now put the cover back on.
Then fasten all the Phillips screws again.
Don’t forget to put the little rubber plugs back in.
Inserting the Sim tray
Insert the sim tray
Attaching the back cover
It’s very easy to put the back cover back on. Put it on in the correct position and press it on all the way around the phone until it’s completely clicked into place.